Get the button and the buttonhole to match
Brazil’s Central Union lists the Basic Sewing honor among its domestic skills. The worldwide Pathfinder honor includes a demonstration of sewing on buttons. Check which requirements your instructor is using. You can show the finished sample and explain how you checked the fit. Central Brazil Union honor categories in Portuguese. Adventist Youth Ministries Basic Sewing Honor.
For your sample, get a sturdy scrap, a strip with a finished buttonhole, a four-hole button that fits, thread, a needle suited to the fabric, and a wooden toothpick. The toothpick is a spacer that keeps a little room under the stitches while you work. If you have yet to make a buttonhole, ask your instructor to prepare the strip. Set the needle and scissors in an agreed place on the table whenever you put them down.
Push the loose button through the buttonhole first. Then place the strip over the scrap to see where they line up. Mark a spot for the button under the center of the opening. A button sewn too far to one side can pull the strip during closure even if the space under the button is right.
Read alsoPathfinders in Casablanca, Cuba: a club meeting that fits on one tableSew with the spacer in place
Thread the needle and secure the thread on the back of the scrap. Bring the thread up through one hole. Set the toothpick on the button and take the thread over it, down through the paired hole. Repeat for the other pair of holes with similar tension. Two parallel lines make it easy to see which holes you have used. Before tying off, remove the toothpick and lift the button gently. Wrap the thread around the stitches that run between the button and the cloth. That makes a short thread shank, a small post that holds the button above the fabric. Secure the thread on the back and ask your instructor to check your first stitches. Oklahoma State University Extension sewing technique cards, buttons.
Button the sample to see what needs adjustment
Button and unbutton the sample a few times. Look at the edge of the strip. If it bunches up beside the button, see if there is room under the button for the strip. If the space looks fine but the strip pulls to one side, compare your mark with the center of the buttonhole. The opening size is a third possibility. The test with the loose button helps you tell a small buttonhole from a button sewn very close to the scrap.
Try a thicker strip if you have one with the same size buttonhole. Note which strip lies flat and which one would benefit from more space. The button can pass through the opening and still squeeze the fabric once it is fastened. University of Florida Extension explains how a shank leaves room for the layers of fabric to close. University of Florida guide to sewing on a button.