The third Campus Party Weekend Piauí is scheduled for November 21 and 22, 2026, at the Teresina Convention Center in Brazil. The Campus Teachers program lists a workshop on drawing planetary orbits with Alberto Alves de Mesquita on November 22 from 4 p.m. to 5:50 p.m. in the Workshop Supernova space. The organizer advertises free admission, with ID and proof of registration needed at check-in. Check the program and entry rules for your age group. Campus Teachers program and opening and check-in hours.

Set two fixed points on paper

Advertisementpreview

An orbit is the path one object takes around another. In the model described by Kepler’s first law, a planet’s orbit around the Sun is an ellipse. An ellipse is a closed curve defined by two fixed points called foci. One of those points is a focus. The Sun is at one focus in this model. NASA guide to orbits and Kepler’s laws

Use a sheet of paper, a cardboard backing, a ruler, a pencil, two pins and string that does not stretch. Have an adult insert and remove the pins. Draw a line through the middle of the paper and mark two points 8 centimeters apart. Tie one end of the string to each pin, leaving 18 centimeters free between the knots. The free length of the string has to be longer than the space between the pins.

Read alsoComics at Barueri’s Gibiteka: draw a four-panel strip for your Pathfinder unit

Draw the curve with the string pulled tight

Press the pencil against the middle of the string until the string is taut. Now there is one segment of string from the pencil to each pin. Keep the pencil upright and move it without pulling the pins from the board. Draw on one side of the line, and then repeat on the other side to close the ellipse. At any point on the curve, the two distances from the pencil to the pins add to about 18 centimeters. This is often called the gardener’s method. Federal University of Recôncavo da Bahia activity on orbits

Advertisementpreview

Draw a small Sun where one pin was. Measure from that spot to the two ends of the curve along the original line. In a carefully drawn model, the distances should be close to 5 and 13 centimeters. Put paper dots at those two ends and mark them “near” and “far.”

Compare it with a rounder orbit

Make another drawing with the same 18 centimeters of free string and space the pins just 2 centimeters apart. The new curve looks rounder. Measure from one focus to its two ends. Expect results close to 8 and 10 centimeters. The shapes in this exercise were chosen to make the difference easy to see.

Lay the drawings next to each other. Ask someone else to place a mark halfway between the two foci to show the center. Label the results as measurements of your model. Real planetary orbits have other sizes and shapes, and many look almost circular.