What is a Great Ball Contraption?
A Great Ball Contraption, or GBC, is a ball run made out of modules. Each module is a section that receives balls and sends them to the next section. Builders follow an agreed standard so that different modules can work together. The standard describes what the incoming area looks like and how many balls must be able to pass through. Great Ball Contraption community, module standard
The North American Division lists two 2026 honors, Great Ball Contraption and Great Ball Contraption – Advanced. The advanced honor describes an original module that works as part of a larger display. This exercise lets you practice handing a ball off to another pair. Ask your counselor which requirements your club uses for the honor. Official list of honors · North American Division, advanced honor
When is BrickFair Richmond 2027?
The LEGO fan expo is scheduled to open to the public on April 3–4, 2027, in Richmond, Virginia. The organizers list Great Ball Contraption among the exhibition themes for that edition. If you are exploring from home, read the community standard and choose a video of a ball run to see where one module sends the ball to the next. BrickFair, public dates · BrickFair, exhibitor themes
As you watch, spot the part that receives the ball and the part that sends it on. See whether the ball drops into a bin, moves onto a track or exits down a ramp. What did the builders put at the handoff that keeps the ball moving through the display?
Read alsoPathfinder Ice Skating honor: from the 2027 U.S. championships to your first lessonConnect two ramps at a shared handoff point
1. Make two channels. Each pair folds up the sides of a strip of card stock. Leave a floor about 6 cm wide so a ping-pong ball can pass through. Support the channels on stable books or boxes and put an empty box at the end to catch the ball.
2. Agree on the handoff. Line up the center of the two channels. To start, set the first exit 8 cm above the table and the second entrance 7 cm up. Put the second entrance right below the first exit. Each ramp should slope downward in the direction of travel.
3. Try the handoff. Release the ball from the first channel and watch it reach the second. If it goes out the side, shift the second entrance. If the ball hits the bottom of the entrance, check the heights. Try again with the same ball and write down what you changed.
Try an example. One pair adjusted the height of the first exit. The other placed the second ramp a few centimeters to the left. In the example, the ball fell off the side. The pairs marked the center of each end with pencil, lined up the marks and ran the test again. Record the exit height, entrance height and handoff position so another pair can copy them.
Further reading: Great Ball Contraption community, standard