Pick one knot to measure
Macramé is the craft of joining cords with decorative knots. Brazil’s Central Union records that Macramé was added to the list of honors in 1975. The worldwide Pathfinder Macramé Honor asks how much cord it takes to reach a desired finished length. This activity gives you a way to answer for your own sample. Ask your instructor which edition and project your club uses. History of the honors, Central Brazil Union in Portuguese. Adventist Youth Ministries Macramé Honor.
Try a macramé square knot. The outer cords wrap around the two center cords, and the two halves of the knot start on opposite sides. Kansas State University’s 4-H guide shows the half knot and how to complete the square knot. Use one type and thickness of cord throughout your sample so you can see how each of the four lengths changes. Kansas 4-H macramé guide.
Measure all four ends before and after knotting
Secure four lengths to a clipboard and line up their starting points. Leave enough free length for six knots and a few inches of tail. Measure from the starting point to each end and write down the four original lengths. Label the left outer cord, the two center cords, and the right outer cord. Tie six knots with a similar amount of pull. Keep any special attachment or finishing knot outside the measured section.
Measure the untied length below the last knot without stretching the cord. Subtract that length from the amount you started with. Suppose an outer cord starts with 45 cm and has 27 cm left. That section used 18 cm of the cord. If a center cord went from 45 cm to 39 cm, it used 6 cm. Those figures are examples for the math. Record the difference for each of your own four pieces.
Read alsoFASC 2026 in São Cristóvão: work out the materials for each pieceUse the results to plan twelve knots
Twelve knots make two groups of six. In the example, twelve knots would use about 36 cm of the measured outer cord and 12 cm of the measured center cord. Add room for attaching the piece, finishing it, and holding the ends as you work. A Purdue University Extension 4-H macramé belt project gives different cut lengths for the center and outer cords. Purdue University Extension macramé belt project.
If you still have enough cord on the sample, tie another six knots the same way. Measure how much more cord they used. If you get a different result, check your knot sequence, how hard you pulled, and where you started the measurement. When you test another type of cord, keep those results separate.
If one outer cord used 18 cm and the other used 20 cm, keep both numbers in your notes. To cut both outer cords to the same length, start with the larger result and leave extra for finishing. In the twelve-knot example, that gives 40 cm of predicted use for each outer cord before you add the finishing allowance.