What did Quito's Interactive Science Museum announce?

On November 9, 2026, the Quito City Museums Foundation published the Interactive Science Museum schedule. It listed ¿Cómo no se pincha?, an activity about pressure and how a force spreads across a surface, for November 13, 20, and 27, with time slots for school group bookings. Check with the museum for any visit arrangements. Your club model uses a block and modelling clay rather than the museum equipment.

Advertisementpreview

What changes when the same force spreads over a larger area?

The OpenStax physics textbook explains that pressure is force divided by the area it acts on. A force is a push or pull. A contact area is the patch where two surfaces touch. Your block weighs the same both times. The contact area changes when you rest it on a different side.

Read alsoScience in Jaciara: what a control group does in an onion root study

Make two marks with one block

1. Ask your counselor for a rectangular eraser or a small block. Look for a wide flat side and a narrow flat side that can each rest without tipping.
2. Make two equal pieces of the same modelling clay. Flatten them to the same thickness on a firm tray. Label one wide side and the other narrow side.
3. Rest the block on its wide side for 10 seconds. Do not push with your hand. Lift it straight up. Repeat with the narrow side on the other piece.
4. Compare the width and depth of the marks. Write down what you saw even if the marks look alike. If the block tilted or one piece of clay was thicker, note that before trying again.

Advertisementpreview

Compare the model with a backpack strap

Imagine a force spread over 4 cm² and the same force spread over 8 cm². If the entire area touches, the average pressure on the larger area is half as much. The dent in clay does not have to be half as deep. The clay can bend or spread in ways the simple pressure calculation does not describe.

Write four lines: object, side, time, and mark. Ask another Pathfinder which part of the test was different. Then put an empty backpack on the table. Sketch the part of the strap that would normally touch a shoulder. You do not need to press it against anyone. Your model teaches contact area. It does not measure comfort or tell you how much weight to carry.

Before you repeat the test, write down what you expect: “I think the narrow side will leave a deeper mark.” Leave a separate line for what happens. If both marks are too faint to compare, keep your first guess and record what you saw. This lets the unit separate a prediction from an observation, even when the test does not give a clear result.