What was announced for Reciclar com Arte in Rio?
The sponsor PPSA announced the exhibition at Parque das Figueiras, beside Lagoa Rodrigo de Freitas, for November 10–23, 2026, with free admission. The posted hours are 9 a.m. to noon and 1 to 6 p.m. The project presents ways to reuse plastics, with an emphasis on bottle caps and examples of extrusion and injection molding. It also shows work by artist Sandro Rodrigues. Check the available sessions and admission arrangements with the organizers. PPSA, Reciclar com Arte announcement.
How can an opening or a mold shape a piece?
In extrusion, material is pushed through an opening that gives it a shape as it comes out. A long strip can keep the same cross section, the shape you see when you look straight down the end or imagine slicing across it. A strip with a square cross section can keep that square outline when cut into different lengths. People can use plastic extrusion for products such as long profiles or wire coatings. Federal Institute of Rio de Janeiro, plastics processing course outline. MIT course materials on extrusion.
In injection molding, a machine pushes material into a cavity, the empty space inside a closed mold. The material takes on the shape of that space, and the piece can come out when the mold opens. The mold can give different parts of the piece different shapes. For example, it could give one side of a part a raised symbol while the other side is flat. MIT OpenCourseWare lecture on injection molding.
Read alsoAmazonian Robusta Coffee Fair in Cacoal: model a peaberryCompare the strip and a whole paper part
1. Fold a wide strip of paper into four equal panels and tape its edges together to make a square tube. Make two tubes with the same panel width and different lengths. Slide one through a square opening an adult cut in a piece of cardboard. Draw an arrow for the direction it moves.
2. Make a new paper piece that is narrow at one end and wide and round at the other. On a folded sheet, draw a cavity with the same outline. Put the paper piece inside and close and reopen the sheet.
3. Look straight into the ends of both tubes to check whether the outline stays square. Look at the narrow and wide ends of the piece from the second model. Mark where the shape changes.
4. Ask another pair which model represents making a long strip with the same cross section. Have them point to the model that can show how a part with different ends gets its shape.
You have already folded the tube before it goes through the opening. The demonstration helps you see where an extrusion machine would give the material a shape. The other sheet stands in for the shape inside a mold. Your club can work with paper and tape for both demonstrations, without heating plastic.