What difference does a high tide make?

A gate can open or close a passage for water. Marina Barrage has nine crest gates. At low tide, extra water can flow out of the reservoir through those gates. At high tide, pumps can move the excess towards the sea. The barrage is part of a flood control system for low-lying parts of Singapore such as Chinatown and Boat Quay. PUB. Flood control at Marina Barrage

Advertisementpreview

Your model uses tap water in both cups. When two open vessels are connected near the base, water flows from the side with the higher surface towards the lower one. The surfaces come closer to the same height as water moves. For the demonstration, both water lines need to begin above the opening of the tube. OpenStax. Water levels in connected containers

Set up a tabletop gate

Ask an adult to prepare two clear plastic cups joined near the base by a snug flexible tube with watertight connections. Stand both cups in a flat tray. Use a clip to pinch the tube shut and act as a gate. Set out a ruler, marking tape and a large needle-free classroom syringe for the second part. Test the gate with a little water and check the tray for unwanted leaks.

Label one cup “reservoir” and the other “sea”. Close the tube. Fill the reservoir to 4 cm above the tray and the sea to 2 cm. One person writes down the expected direction. Another releases the clip. See which line falls and which rises. In this low-tide model, the reservoir level falls as water moves towards the sea.

Read alsoCeramics in Brazil’s Espírito Santo: learn about the Goiabeiras potters and try hand modeling

Swap the starting levels and model a pump

Close the tube and swap the starting heights. Now the sea is at 4 cm and the reservoir is at 2 cm. Open the tube for a moment and watch what happens. Return the cups to their starting levels. Close the tube and use the syringe to lift some water from the reservoir over to the sea cup. The syringe plays the role of the pump in the exercise.

Advertisementpreview

Compare your results. In the first test, the water moved in the desired direction when you opened the tube. In the second, you had to lift it by hand to send it to the higher side. Ask another pair to point to the water lines before they choose a tool and predict which way the water will move. After the test, have them check the prediction against the marks.

Try a third case with equal water levels

Set both cups to 3 cm and open the clip. Let the water settle. Do the two marks stay at the same height? If a level falls and the tray gets wet, check the tube for a loose connection. If one cup sits higher than the other on the tray, put both on the same surface and measure again.

Use one arrow for your prediction and another for the observed direction in each trial. When you use the syringe, write down how much you moved, such as 10 mL. The ruler tells you the water's height, while the syringe tells you the volume you transferred.

Further reading: PUB. Marina Barrage