The activity takes its cue from Argentina’s 2026 CANSAT Secundario challenge for secondary schools. On November 12, Argentina’s National Commission for Space Activities (CONAE) announced five teams from Buenos Aires, Córdoba, and Mendoza provinces. Their launch campaign is scheduled for December 9 to 11 at the Teófilo Tabanera Space Center in Córdoba Province. CONAE says the teams transmit flight data, including readings of air pressure and temperature during descent. This Desbravai paper activity is separate from the event and can be done without radios or sensors.

What is CanSat telemetry?

Advertisementpreview

A CanSat is a small device about the size of a soda can. It lets teams practice parts of a space mission at a smaller scale. In this competition, the prototype flies and collects data without needing to go into orbit. Telemetry means sending readings from an instrument to someone who receives them at a distance. A pressure reading tells you how hard the air is pushing against a surface. One unit is the hectopascal, shortened to hPa. In this game you copy the pressure numbers with their units. You do not need to turn them into heights.

NASA explains that when teams receive and store science data, parts of the record can be missing at first. Each slip in the Pathfinder model stands for a small set of data that was sent. It carries the second when the reading was taken, even if the message reaches the table later.

Sort the five slips by measurement time

Make five rows, one for each second from 1 to 5. Add a pressure column and a temperature column. Ask the sender to write the following pretend readings on separate slips and hand them over in the order listed here:

1. Second 2 — 891 hPa and 16 °C.
2. Second 4 — 895 hPa and 17 °C.
3. Second 1 — 889 hPa and 16 °C.
4. Second 4 — 895 hPa and 17 °C, again.
5. Second 5 — 897 hPa and 17 °C.

As the receiver, write each reading under the second on the slip. Second 1 arrived after second 4 but still goes first in the table. The two messages for second 4 give the same readings. So instead of five separate times, you have data for four. Label second 3 no reading received. If you draw a pressure graph, leave a gap there. Putting a dot at zero would claim the team measured zero, which it did not.

Read alsoMIS Maringá 2026: what happens when two film frames play out of order?
Advertisementpreview

What do you do when the missing slip comes in?

After the first check, give the receiver one more slip: second 3 — 893 hPa and 16 °C. The team can fill the gap and write a note that the message arrived late. As a second challenge, ask what would happen if another message for second 4 said 899 hPa. Mark the two readings as conflicting and check their origin. The newest slip in the stack is not automatically the one you should keep. Finish by showing the table to another unit and naming the difference between time measured and order received.

Show which slip supports the new number

Compare two small copies of your table: one with the original gap at second 3 and one with the late reading and its arrival note. Ask someone who did not watch the activity to explain what changed. If they say, “You guessed 893,” let them find the matching slip. Even though 893 falls between 891 and 895, that alone does not tell you what the instrument measured. To settle the conflict at second 4, ask the sender for the original record. Don't choose a number just because it makes the line on your graph smoother.

Words in this guide

telemetry · Measurements sent over a distance, such as temperature readings received by a team on the ground. Back to the term