What Hugo França shows at Vila Velha

The Oscar Niemeyer Museum announced an opening date of November 12, 2026, near the Furnas section of Vila Velha State Park in Ponta Grossa, Paraná. The museum lists the exhibition through March 2027 without identifying a final day on its page. The eight large sculptures were made from 2017 to 2024 using roots from trees such as pequi, imbuia and jatobá. The artist works with tree parts that people often discard. Check with the park for current access and visit arrangements. Oscar Niemeyer Museum. Paraná State News Agency.

Advertisementpreview

When you look at a sculpture, see where it touches the ground or rests on something else. You can sketch the contact point from the visitor area. The small model your club makes lets you investigate one question about balance on a tabletop.

What the center of mass tells you

The center of mass is a point that helps describe how an object's mass is distributed. A strip with the same material all along its length tends to balance near the middle on a narrow support. A paper clip adds mass on one side. To balance the strip again, try moving the support toward the clipped end. Brazil's Museum of Astronomy and Related Sciences uses the same concept in an experiment with a cork. MAST balancing cork activity.

Read alsoCeramics in Brazil’s Espírito Santo: learn about the Goiabeiras potters and try hand modeling

Find two balance points with one piece of cardboard

Advertisementpreview

Gather a strip of firm cardboard, a pencil, tape, a ruler and a small paper clip. Work close to the tabletop. Tape the ends of the pencil down so it cannot roll. The cardboard should cross over the middle of the pencil.

1. Put the strip on the pencil without the clip. Slide it until both ends stay off the table. Mark the contact point A.
2. Add the paper clip near the right end. Try balancing the strip at A again and notice which end drops. Change to firmer cardboard if the strip buckles.
3. Keep the clip on the strip and look for another spot where both ends stay up. Mark it B, then measure the distance along the strip from A to B.
4. Invite another pair to try it. Ask whether their second balance point lies toward the clip. Try moving the clip closer to the end if the difference is difficult to see.

Draw the strip and mark where you put the clip, where it balanced both times and the distance you measured. Give the drawing a label that says it shows your model. A sculpture with another shape or a different material can balance differently.

You can check the effect of the clip's position by sliding it halfway back toward A. Try to find a third balance point with the new arrangement. Mark it with a date or a new letter so it stays separate from your first two results.