Which paper project appeared at Eureka 2026 in Callao?

The Regional Education Directorate of Callao, Peru, published its results for the UGEL stage, a local education administration round. The project from school 5076 Nuestra Señora de las Mercedes placed first in the round’s Category A science and technology inquiry area. Its title describes making handmade paper from panca de choclo and recycled paper. Panca de choclo is a local term for the husk wrapped around an ear of corn.

Advertisementpreview

Peru’s Ministry of Education publishes the national rules for the Eureka school science and technology fair. The placement cited here comes from Callao’s local round. Pathfinder units can take inspiration from the project and develop their own test using scraps already available to them.

How does water drain out of paper pulp?

Pulp is a wet mixture that has tiny paper fibers spread through it. A screen catches some fibers while water goes through the holes. A buildup at one edge may leave the opposite edge with a thinner layer. The Cornell Waste Management Institute describes using a screen to collect pulp, allowing it to drain, and pressing more water out before the paper dries.

Picture a thin layer of pulp on a tilted tray. You might see some pulp shift toward the lower edge as water runs out. Your particular mixture might also stay where you put it. Watch and keep a record so the next group will know what happened under the conditions you used.

Read alsoRoboKits at the Piriápolis science fair: program a paper curtain with Pathfinders
Advertisementpreview

How to make two sample sheets

Get a basin, a spoon, a small measuring cup, two matching screens with protected edges, two flat pieces of cloth, and towels. Tear plain uncoated paper into small pieces. Soak it and ask an adult to prepare one batch of pulp with water. Protect the table and keep the screens over the basin so it catches the water.

1. Assign one person to mix, one to time the trials, and one to draw the results. Stir the pulp before measuring two equal portions. Label the cloths A and B.
2. Spread the first portion on a flat screen. Leave it flat for 15 seconds while water drains. Use cloth A for this sheet.
3. Spread the second portion the same way. Raise one side a little using a solid support while keeping the screen over the basin. Time the same 15 seconds. Record which edge was lower on the record for cloth B.
4. Transfer both samples to their cloths and press each one in the same way with towels. Once the sheets dry, place them over a piece of light paper to look for thin areas and holes.

How to decide which sheet spread evenly

Draw each sample and divide the sketch into four parts. Mark holes or places where you can see more pulp. Compare any thicker spots on the tilted sheet with the edge that was lower in the trial. If one sheet tore when you moved it onto the cloth, record that and repeat the comparison. Keep the dry sheets with your sketches so another unit can check the observations against both samples.