Tell a raised relief from a drawn outline
An outline marks the edge of a shape. In relief carving, a figure also rises above the background. Set out a bar of soap, paper, a pencil, a rounded craft stick and an LED torch or flashlight. The Georgia Museum of Art uses soap to show how carving the background can leave a shape standing above it. Georgia Museum of Art: Soap Carvings.
Design a wide leaf with room around its outline. The extra space gives you somewhere to remove soap without cutting into the shape. Set the bar on paper on a steady table and work with adult supervision. Use short strokes. Turn the bar so the tool moves away from your fingers. Ask a partner to sketch what the edge of the leaf might look like from the side when it is raised.
Read alsoAndean metalwork in Quito: a paper relief activity for PathfindersRemove a little soap at each pass
Trace the leaf lightly on the soap. Scrape outside the outline with the rounded side of the stick. Clear the shavings from the surface and compare the height of the background on each side. If one section of background still sits high beside the leaf, work on that section. Give your partner a chance to see it from the side before taking off more material.
Once the leaf stands above the background, use a light line inside it for the center vein. Brush away the shavings if the line seems to vanish. Then decide whether you can already see the detail. One person can write down where they see a clear change in height. That gives you a place to check again with a lamp. South Pacific Pathfinders: Soap Craft trainer's notes.
Move the light from one side to the other
Have your partner shine the light from just above the table on the left. Then have them move it to the right at about the same height. Watch the shadow near the leaf's edge. A groove may also cast a small shadow, so confirm that the broad area of the leaf sits above the scraped background. Turn the bar to see its profile.
If the figure blends into the background in one area, check whether both surfaces meet at the same height there. Make a small correction where you see that problem. Finish by comparing your initial profile sketch with what you can see now. Keep the sketch and make a note about where you stopped. It will help you plan the next Soap Craft piece.