The parts you need to line up

The tire is the outer part that rolls on the ground. In a tire that uses an inner tube, the tube is the rubber part that holds the air. The rim is the ring that holds the tire in place. The valve passes through a hole in the rim so you can fill the tube with air. That hole gives you one fixed point for matching the parts when they have been separated.

Advertisementpreview

Park Tool’s guide shows how to remove and install a tire and tube. It explains that the rim strip protects the tube from edges in the rim that could puncture it. If the hole in the tube faces out toward the tire tread, check the corresponding part of the tire with your instructor. If it faces in toward the rim, also look at the rim strip in that area. The location of the hole tells you where to look for evidence.

Read alsoChile's Mahuida Club: how to find and explain the origin of your Pathfinder unit name

Use the valve to compare positions

Before your instructor removes the tube, mark the side of the tire that faces you. A small piece of removable tape is enough. Mark the matching side of the tube before you turn it over. The valve tells you where to start and the mark tells you which way the parts face. If you flip the tube on the table, the place you were looking for can show up on the opposite side of the valve.

Advertisementpreview

For the exercise have an adult mark an imaginary puncture with chalk on a worn tube. Lay the tube by the wheel and align the valve with the valve hole, with both orientation marks facing the same way. Follow the curve of the tube to the mark. Find the area on the tire or rim that would line up with it and describe what the instructor should check. Avoid running a finger inside an actual tire, where there could be a hidden sharp object.

See if a teammate can repeat what you did

First tell the teammate the hole is near the valve. They could still look on the wrong side. Try giving more detail: “with the marked face up, follow the curve three centimeters to the right of the valve, on the outer side of the tube.” Use your actual practice measurement. Then flip the tube and have them work out why knowing which face was up helps them find the same place again.

If you cannot tell how a real tube was oriented before removal, offer both possible positions. Your instructor can check the matching areas. Tracing a hole is one step in the Cycling honor. Check whether your club expects you to patch the tube, replace it or show a different procedure. Have the responsible adult check the assembled wheel and tire before the bicycle is ridden again.