What do 40× and four millimeters mean?

The eyepiece is the lens near your eye. The objective is the lens near the scale or sample. With a 10× eyepiece and a 4× objective, the total magnification of this compound microscope is 40×. Change to the 10× objective and keep the same eyepiece. The total is now 100×. Both numbers describe how much the image is enlarged in that setup.

Advertisementpreview

The field of view is the part of the scale you can see at once. Its diameter is the distance between the edges of the circle through the center. “40×” describes magnification. “4 mm” might describe how much of the scale fits across the circle. To find that length, look for the markings on the scale.

Measure the circle in two ways

Ask your instructor to set up two low-power objectives on the same microscope, a clear ruler or scale slide and a stable table. An Exploratorium activity uses ruler marks to estimate the field size. Follow your instructor’s directions when using the microscope and changing lenses. Start with the lowest-power objective in the practice.

Set the scale so that the numbered line runs across the center. If one edge is at 1 mm and the other is at 5 mm, the visible section is about 4 mm wide. Find it by subtracting one reading from the other. Slide the ruler closer to a side of the circle. The line you can see gets shorter because it no longer crosses the center.

Change to the second objective with help. Keep the same eyepiece, find the scale and count the markings again. Some marks that were visible with the first objective are now out of view. Record the numbers on both lenses and the millimeters you saw. Two microscopes can have different field sizes even with similar magnification numbers.

Advertisementpreview
Read alsoRio Branco’s 2026 Harvest Week: start a two-week garden log with your Pathfinder unit

Share your result with the next group

In an invented example, the unit measures 4 mm across the field at 40× and about 1.6 mm at 100×. Those example numbers show how the direction of change can look. Record your own measurements. If another pair reports a wider field with higher magnification, ask them to read the numbers on the lenses and confirm they measured through the center in both trials. Ask them to describe what each number measures.

To finish, return to the first objective and locate one mark. Increase the magnification and see whether that mark stays in view. This helps explain why a wider field makes it easier to locate something before you inspect a detail.

Leave the results of both measurements side by side. A new teammate can point to the number for magnification and the number that has millimeters as its unit. If they mix up the numbers, show where you read the marking on the lens and where you put the scale to measure the field of view. Invite them to return to the first objective and check one of the readings by looking through the microscope. Repeating one measurement lets you see whether a second person can reconstruct your observation from the record. Add the objective number if it was hard to find.