What happened at Peru’s Pathfinders APC Mental Phase?

On October 11, 2026, the independent site Club de Conquistadores published an account of the Mental Phase. It reported 926 contestants from 65 clubs at this activity of the Asociación Peruana Central, or Central Peru Conference. Morse code was one of the challenges. The report does not give the actual messages used. The activity below uses its own examples to show how Morse spacing works.

Advertisementpreview

Count the silence as well as the sounds

Morse code uses dots for short signals and dashes for long ones. A beat here means the amount of time one dot lasts. The International Telecommunication Union's Morse code recommendation gives these timing ratios in its technical annex:

• A dot lasts 1 beat. A dash lasts 3 beats.
• A gap between signals in one letter lasts 1 beat.
• A gap between letters in one word lasts 3 beats.
• A gap between words lasts 7 beats.

Fill one square for each beat of signal. Leave one square blank for each beat of silence. For A, draw ■ □ ■■■: a dot, a short gap, and a dash. For E and T, draw ■ □□□ ■■■. The dot and dash are the same lengths, but the three blank squares tell you to start a new letter. If a partner prefers listening, read “signal” or “silent” for each equal beat.

Read alsoTeletón Temuco turns 25: set up an accessible activity table at your Pathfinder club
Advertisementpreview

Make a practice card with two words

Write APC LIMA on a card to check the result. This is a made up message for the activity. On another card, write `·− ·−−· −·−· / ·−·· ·· −− ·−`. In this example, A is `·−`, P is `·−−·`, C is `−·−·`, L is `·−··`, I is `··`, and M is `−−`. The slash on the note marks a break between words. On the timing grid, use seven blank squares where you see it.

Start with AP. Draw A as ■ □ ■■■. Add □□□ before P, which looks like ■ □ ■■■ □ ■■■ □ ■. Point to one gap and count its blank squares. Then finish the rest of the message in the same way. The seven blanks go after C in APC and before L in LIMA.

Give your grid to another pair without showing the answer card. Ask them to mark the gaps first. They can underline each group of three blank squares and circle the group of seven. Then they write down each letter from the list. If their answer has only one word, check for the word gap. If they joined two letters, compare the gap they marked with the timing rules.

At the end, show one pause that changed what your partner read. Say “Three silent beats tell me to start another letter here” or “Seven silent beats tell me the next word is starting.” Your card is ready when another unit can read it without the writer helping. To learn other signals, see Desbravai's guide to semaphore and Morse.