Convert the measurements before shrinking the flag
The bulletin gives approximate dimensions of 1 metre high by 1.5 metres wide. That's 100 by 150 centimetres. To draw it at 1:10 scale, divide both measurements by 10. One centimetre on the page represents ten on the flag. Draw a rectangle 10 cm high by 15 cm wide. A sketch measuring 10 by 12 cm would shrink the width by a different factor from the height. That makes it look closer to a square than the original flag.
Fold the paper in half in both directions or draw two lines through its centre. Each of the four equal parts is a quadrant. On the 10 by 15 cm model, each part measures 5 by 7.5 cm. The Australian handout shows blue in the top left and bottom right on the illustrated face. The club emblem sits in the middle, where the four parts meet. A small paper triangle can mark the emblem's position during your practice session. Your unit can use that rough marker while checking proportions and the position of the club name. Pathfinders Australia, Drill & Ceremony handout sheet 6.
Check the height, width and name in three samples
Write a pretend name such as “Gumleaf Club” on three slips. Keep the top edge of each sketch facing the same way as you work. Ask, “Did both sides get smaller by the same factor?” and “Is the name in the lower-right blue quadrant?” These are practice examples that your unit can draw from the table and check together.
| Sketch | Height × width | Where the name goes |
|---|---|---|
| A | 10 × 15 cm | Upper-left blue quadrant |
| B | 10 × 12 cm | Lower-right blue quadrant |
| C | 10 × 15 cm | Lower-right blue quadrant |
Sketch C has the right proportions and places the name in the right part. A has the correct proportions and the name needs to move. B puts the name in the expected part and needs three extra centimetres of width to stay in proportion at the same height. To practise the placement, slide the name slip above or below the centre line. Use stripes to mark the blue parts if you want the pattern to make sense on a black-and-white copy. Check whether someone can find the spot using only a spoken instruction such as “bottom right.”
Read alsoWorld Wildlife Day 2027: draw a wildlife crossing that makes senseMake a smaller model and explain your check
Challenge another team to try 1:20 scale. That model measures 5 by 7.5 cm and each quadrant measures 2.5 by 3.75 cm. The location of the name within the flag stays in the same relative position. Write the scale below each drawing and give the two models to someone who hasn't seen the example. Can they measure both models and tell which one was reduced more? The exercise works for any club. For a real flag, follow the official specifications in your own field. Pathfinders Australia, Drill & Ceremony resource notes, page 12.
Words in this guide
1:10 scale · Each centimetre in the drawing represents ten centimetres on the real object. Back to the term
quadrant · One of the four equal parts formed by dividing the rectangle in half both ways. Back to the term