What the museum announced for students
In Ecuador, the Fundación Museos de la Ciudad publishes the calendar of the Museo Interactivo de Ciencia, known as MIC. Its November 2026 schedule includes Resonancias with sessions on Fridays 13, 20 and 27 during times reserved for student groups. One activity is about observing how objects interact with surfaces. Check with the museum about bookings. The club experiment below is a separate activity focused on the moment when a box begins moving downhill.
Set up a ramp where just the surface changes
Rest a stiff, light board in a tray on a steady table. Ask an adult to help secure the lower end and clear the area around it. Temporarily tape a sheet of smooth paper to the board and have a dry piece of thin cloth ready for the second round. Add a mark to show where the front of the same small box starts. Keep the cloth flat so a fold does not hold the box in place. Make sure the same face of the box touches the board each time. This setup helps you observe the effect of changing the surface under it.
Catch the first moment the box moves
Put the box on the mark with the board almost level. One person lifts the upper end slowly. Another watches from the side and says “now” as soon as the box moves on its own. Measure the height of the higher end at that point with a ruler, keeping the same board and the same lower support. Bring it down, turn the box back to its starting mark and repeat. Take three readings on each surface and compare them. A teammate can make sure the light box stops on the tray. Try to use the same person to tilt the board each time.
Read alsoScience in Quito: explore backpack strap pressure with your Pathfinder unitSee what is acting before the box slides
As you tilt the ramp, part of gravity’s pull acts along the board. Static friction is a force between the surfaces that opposes the start of movement. When the tilt is large enough for the box to move, you have reached the start of the slide. A different kind of friction acts once the box is moving. That is why you watch for the first motion. Timing the whole journey would look at a different effect, which also depends on the tilt and the box’s movement down the ramp.
Compare two sets of height readings
Suppose the box starts sliding at 5, 6 and 6 centimetres on one surface, and at 8, 8 and 9 on the other. All three trials in the second set required lifting the same board higher. In that example, contact with the second surface offered more resistance to the start of sliding. These numbers show how to compare results. If your measurements differ widely within the same set, see whether the lower support moved, the box turned or the person lifting the board gave it a sudden jerk.
Share what you observed on your ramp
Invite another pair to repeat one test. Tell them which face of the box was touching and show them the starting mark. Ask them to check whether the box moves near the height in your record. If it moves much sooner, look to see if a piece of tape caught on the box or if the cloth was pulled flat. Give a conclusion about the materials you used. “On this board with this box, the cloth needed a steeper tilt” describes the evidence. If you want to know what changes with a new box, set up another round.